Is this the right intake manifold????? - Team Camaro Tech
Engine General Engine Discussion.

LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old Feb 28th, 10, 08:48 AM Thread Starter
Senior Tech
Join Date: Feb 2009
Location: California
Posts: 133
Is this the right intake manifold?????

I recently purchased the edelbrock performer #2101 for my chevy 350.
Its a 80's block im told with cast iron heads. Will this fit? When i put it on it sits good, but over laps in the front of the engine a little bit.

my block # is - V0324FSF

I cant figure this out... can someone help???
brianstevens03 is offline  
Sponsored Links
post #2 of 2 (permalink) Old Feb 28th, 10, 09:16 AM
Senior Tech
parkbrau's Avatar
Join Date: Sep 2004
Location: Stuttgart
Posts: 7,683
Re: Is this the right intake manifold?????

What is a little bit? 1/8 or so? My 2101 overlaps a bit kinda 1/8"
parkbrau is offline  
Sponsored Links

Quick Reply

Register Now

In order to be able to post messages on the Team Camaro Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address.
NOTE we receive a lot of registrations with bad email addresses. IF you do not receive your confirmation email you will not be able to post. contact support and we will try and help.
Be sure you enter a valid email address and check your spam folder as well.

Email Address:


Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome