To be brief, I had the car at a shop to get a new engine rebuilt along with suspension etc. They took my money, most of my stock original parts and almost my car. I just put in a SBC 383 with a MSD dist. and 6al box.
Its been 8 years since the car has ran, and I dont remember what wires go to or what I even need to use anymore. The car was a A/C car, and I removed it. Im sure some of the wiring wont be used.
I need to know what wires go to what. I took pictures of the factory wiring that I dont know what they are used for. Hopefully you can help me out.
These wires are near the stock washer fluid tank, on the driver side. I believe 2 of them go to the voltage regulator?
This wire goes into the firewall.
These three come out of a harness that goes the length of the firwall and come out above the washer fluid pump.
Passenger side of car, starting closest to fire wall toward front of car. The harness these wires come out of, comes out of the firewall above the passenger side valve cover.
1 wire connector.
Last connector, wire is green and very long, it runs toward the front of the car.
1 connector and 1 eyelet these run out of a harness that comes out of the passenger side wheel well.
This wire Behind the radiator support.