Wiring clip? - Team Camaro Tech
Electrical & Wiring Troubleshooting electrical.

 
LinkBack Thread Tools Display Modes
post #1 of 3 (permalink) Old Sep 19th, 02, 04:14 AM Thread Starter
Senior Tech
 
Join Date: Jan 2000
Location: Grand Ledge, MI 48837 USA
Posts: 366
I have been trying to find the correct wiring clip (holder) that mounts to the upper right flywheel bolt and holds the wires going to the starter solenoid. This is on a 69 camaro small block. The AIM says it's part of the wiring harness so there is no part number listed. I don't believe it's being reproduced so an original is my only choice. Anyone out there have any ideas on who to call or contact about one of these? Or better yet, have one they are willing to sell. Any help would be greatly appreciated.
kurt6325 is offline  
Sponsored Links
Advertisement
 
post #2 of 3 (permalink) Old Sep 19th, 02, 10:11 AM
Senior Tech
 
Join Date: Feb 2002
Location: Williamstown,PA
Posts: 500
If you're refering to the rubber coated metal strap that is held in place by the bellhousing (not flywheel) bolt, I think I can help. If you can't find one pre-made. All you have to do is cut a piece of sheetmetal 1/2" wide and about 2" long. Drill a 3/8" hole at one end. Buy a can of black dipping compound used for coating tool handles and coat the strap except for 1/2" at the end with the hole. After the rubber sets up, bend it in a loop by wrapping it around a drill bit or a punch slightly smaller than the diameter of the harness. You can then spread it open to put the harness in and then pinch it on.

------------------
'69 RS Camaro
355 5-speed 4.11
1 2RUN is offline  
post #3 of 3 (permalink) Old Sep 20th, 02, 05:23 PM
Senior Tech
 
Join Date: Apr 2002
Location: san diego
Posts: 127
I recently purchased an engine wiring harness from Classic Ind. in Orange County for my '69 Z28. It included the correct bellhousing clip. Mayby you could find the source of the harness and purchase one from the supplier.
If you are looking for the positive battery cable clips for the oil pan, I found some at NAPA that I modified that were real inexpensive. Good Luck.
clm69z28 is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Team Camaro Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address.
NOTE we receive a lot of registrations with bad email addresses. IF you do not receive your confirmation email you will not be able to post. contact support and we will try and help.
Be sure you enter a valid email address and check your spam folder as well.



Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome