Reproduction Decals - '67 - Team Camaro Tech
Tech 2001 General Tech questions from 2001
Replies ONLY, no new topics.

 
LinkBack Thread Tools Display Modes
post #1 of 7 (permalink) Old Oct 23rd, 01, 07:46 AM Thread Starter
DWL
 
Join Date: Aug 2001
Posts: 74
Question

Were the decals listed below used on the '67 model? If so, where exactly are they attached?
-Anti-freeze decal
-Dealer-installed anti-freeze decal
-GM Door Mark (foil), driver and passenger door?
THANKS!!!

------------------
Dallas
67 SS 350
DWL is offline  
Sponsored Links
Advertisement
 
post #2 of 7 (permalink) Old Oct 25th, 01, 03:08 PM
Stephen Dale
Guest
 
Posts: n/a
Post

In Re. door decal, is this @ 2" square? As to the underhood decals I will be happy to go from memory as mine are long gone. On the radiator support in front of the cap @ on center going to driver,s side.

------------------

67 Nemesix
post #3 of 7 (permalink) Old Oct 26th, 01, 02:19 AM Thread Starter
DWL
 
Join Date: Aug 2001
Posts: 74
Post

Stephen,
The GM Door Mark (foil or stamped metal) is @2 inches square. I'm not sure where on the door inner panel it is attached. I'm also not sure if both doors received this decal.

Did first gens get both the factory anti-freeze decal and the dealer-installed anti-freeze decal?

Thanks!

------------------
Dallas
67 SS 350
DWL is offline  
 
post #4 of 7 (permalink) Old Oct 26th, 01, 02:47 AM
Senior Tech
Mark
 
Join Date: Sep 2000
Location: Shrewsbury, MA, USA
Posts: 6,513
Post

The door foil GM marks were only used on 67's, (and possibly 70 and later) and they are located with the bottom edge about 1/4" above the top edge of the upper door strike screw, and the right edge (passenger side) about 1/4" to the left of the same screw.

If you place the lower corner of the foil closest to the upper strike screw 1/4" to 3/8" above and outboard of the edges of the screw you will be in the right spot.

They were used on both drivers and passenger side doors.


------------------
Mark Canning
1969 Indy Pace Car
350/300HP RPO Z11
My 69 L48 - 350/300HP Engine


[This message has been edited by Mark C (edited 10-26-2001).]
Mark C is offline  
post #5 of 7 (permalink) Old Oct 26th, 01, 03:32 AM Thread Starter
DWL
 
Join Date: Aug 2001
Posts: 74
Post

Mark,
Thanks for the details. Can you provide any input on which anti-freeze decal(s) were used and exactly where they are located? I'm attempting to put the final touches on a '67 restoration.
Thanks again!


------------------
Dallas
67 SS 350
DWL is offline  
post #6 of 7 (permalink) Old Oct 26th, 01, 01:10 PM
Stephen Dale
Guest
 
Posts: n/a
Post

Maybe the decals were hand applied. Mine are 3/8" outboard 1 1/2" above screw. Never saw two a/f decals on a car before. Check your area for a Concoure event. Ask the judges & entrants if there is supposed to be a specific location for them. Never really paid it much thought until you asked!

------------------

67 Nemesix
post #7 of 7 (permalink) Old Oct 26th, 01, 01:27 PM
Senior Tech
 
Join Date: Aug 1999
Location: Sacramento CA
Posts: 235
Post

GM sticker on both doors and the posts as to postion are accurate. I'm not sure about the A/F decals, I've had 2 bone stock 67's and neither one had a decal, nor does my 69 Z28. Whatever you do, don't put one of those "Caution Fan" stickers on the shroud. Ugh!
Ed Ernst is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Team Camaro Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address.
NOTE we receive a lot of registrations with bad email addresses. IF you do not receive your confirmation email you will not be able to post. contact support and we will try and help.
Be sure you enter a valid email address and check your spam folder as well.



Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome