Team Camaro Tech banner

gears

  1. Muncie Case Damage

    Transmission & Driveline
    I got my Muncie pulled apart today. I was expecting some carnage inside... and wasn't disappointed! My 1st gear had a few teeth completely stripped off and the countershaft had a number of teeth worn down as a result. It was ugly. I will of course need to order replacements for those two...
  2. 10 bolt 8.2", gearing swap

    Transmission & Driveline
    Hi, I realize that I dont know how the gearing can be changed in my rear axle (as in title). After searching this site and others I think my rear axle with 2.73:1 needs a new carrier/casing to be able to install higher gears. I would like to go to 3.36 or maybe 3.55 *(and posi) but what parts...
  3. 10-bolt gear from a chevy van

    Transmission & Driveline
    Hi, I have been offered a 10-bolt open rear axle from a chevy van (don't know what year) for $150. It's a good price here in Sweden. My thought is to buy it and upgrade the rear axle on my -67 Camaro from 2.73:1 to 3.42:1 I am asking this because I dont know if the pieces will fit into my...
  4. 700R4 Speedo gears

    Transmission & Driveline
    I have a 700R4 with 3.73 gear and 27.25 tire, original speedometer in a 68. I was registering over 20MPH off @ 70MPH. (between 90& 100) I checked with a vendor that suggested a 17 drive and a 45 driven. I installed this setup and now I am 6MPH off @ 50-60. I could also have used a 15/41 but the...
  5. Best Rear End Gear for 68 Powergilde

    Transmission & Driveline
    I am not a car guy (never been in an auto shop class) but I am turning into one. I am 43 and loving this project. :) I am doing a jack stand restore on my wife’s first car. It is a 68 plain Jane 327/210hp, powerglide, single leaf (Do not know much more that that). I am going to keep my trany...
  6. 68 Plain Jane 327 - Jack Stand Restore

    Restoration Corner
    Ok, so I am not a car guy (never been in an auto shop class) but I am turning into one. I am 43 and loving this project. :) I am doing a jack stand restore on my wife’s first car. It is a 68 plain Jane 327, power glide, single leaf (Do not know much more that that). All is going well since it...
  7. Gears? Advice?

    Performance
    i just bought a 92 camaro rs with the 305 tbi engine, i'd like to get some good gears in it mainly to help off the line, i have very little torque right now with these stock gears. any help on what brand, and ratio would be greatly appreciated, thanks in advance!
Top