Search Results for ‘hei’

Hello Everyone, I am restoring a 67 Camaro and the wiring was a mess and wiring is not my thing. I ordered a new Engine harness (CA71982) it has these wires that I'm not sure what they go to. I'm thinking the distributor but I have a HEI style so not sure how to wire them

Hi everyone, So I recently rebuilt my engine and in the process upgraded my points distributor to an HEI, and my factory starter to a mini starter. The factory starter had 3 terminals (Battery+, S, R), and the new starter has 2 terminals (Battery+, S). Based on the instructions and what I read...

Point me in the right direction. Just installed a pertronix HEI rebuild kit, basically everything except the pickup coil. Car ran great right away. Next day, it took a second to start after getting gas. It always starts great. Worked fine after that. A few days later, wouldn't start at...

All, Recently my 1969 Camaro just stopped starting so I have replaced the starter with a new rebuilt starter, but no change, tried different batteries with no change, metered out the wires at the neutral safety switch, 12vdc coming in 12vdc coming out, and metered out the wires going to the...

Hey guys - I've officially given up on the stock HEI as I keep nuking the ignition module. So, it's time to upgrade. I'm think MSD. Anyone have experience with a particular model # in this application? WIth 6AL box? Any other advice from folks who have been through this? Thx, Nick

Can anyone tell me where I may purchase replacement parts for a GM HEI distributor? I need bushings, springs, weights vac. can. I have installed an aftermarket distributor but would like to rebuild the GM. I have checked the web and many locals with no luck. I do not like the kits from Accel...

Question # 1: I am going through my GM HEI distributor. Under the weights there are nylon pads that the weight slides on, does anyone know where I can get them, I have been unable to find. Question # 2: I installed the one wire alternator, no problem other than the alternator light now stays...

I have a 69 camaro, 350, stock with a points distributor and a 12v Accel coil. The points distributor only has 1 wire (ground/black wire) and it is connected to the coil. I do not see a ballast resistor anywhere. I just purchased a ready to run distributor and a new 12v coil but I need help...

MSD Street Fire HEI Distributor P/N 8362 $120.00 Shipped (48 U.S. States) http://cs3automotive.com/index.php?a=PROD:1776

I have an 85 Series Mallory HEI wired to a HyFire 6A box. I'm adjusting the vacuum advance using an allen wrench inserted into the nipple on the vacuum module. Is there a good rule of thumb to use when doing this? Like, 3 turns counter clockwise from fully tightened or is it just major trial and...