Team Camaro Tech banner

installation

  1. Camaro Tech
    I know they say there are no silly questions, but this may be one...:crying: I'm replacing my fuel line from tank to pump. Car is on jack stands. I have the new fuel line. But how do I get the line out from the tank and how does the line attach to the fuel sending unit? Currently I have not...
  2. Engine
    Hi, I am going to replace the intake manifold gasket. Have bought a kit from MrGasket that contains the 2 gasket for each cylinder head face and the 2 rubber gaskets for the front and end surfaces. 327 engine. Intake manifold: older Edelbrock Performer 2101. Have a few questions about the...
  3. Brakes, Suspension & Steering
    OK, I've searched, I've read the instructions, I've tried to figure out the "flat" side of the spring, and I still can't figure this out. One post from Hotchkis says, "the flat side is up, you are on the flat side when the spring doesn't lean." Mine lean on either side. Both sides seem...
  4. American Auto Wire
    In this video series that coincided with the release of our 1959-1960 Impala Classic Update kit, Don Bock chronicles the installation of the kit in a 1960 Bel Air. The fifth episode premiered Monday, check them all out! In other news, American Autowire recently released our new 1970 Mustang...
  5. Brakes, Suspension & Steering
    So I'm trying to install a reproduction wheel on the camaro I just got, and I've run into a problem when removing the silly looking old racing wheel. The metal middle piece that slides over the gear is stuck. I'm not sure how to get the thing off. Is there some special screw I'm missing, or do I...
Top