Team Camaro Tech banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-13 of 13 Results
  1. Brakes, Suspension & Steering
    Does anyone know how to access the top bolt for the passenger rear shock on a 68 convertible?
  2. Interiors
    It's not always there. I hear it loud, when driving on uneven surface, and sometimes at idle. It sounds like it's coming from behind the rear interior quarter trim (passenger side). Noise is from the inside, not outside. I checked everything, but can't figure out where it's coming from. It's...
  3. Member Classifieds
    I'm selling these brand new Viking adjustable shocks model B227 that fit the 67 - 69 Camaro and Firebird rear shocks. I installed this on my 67 Camaro that is just sitting in the garage but never used them or drove on them so they are brand new. They come in the factory box with instructions &...
  4. Convertibles
    Rear side window in about a 1/2" to far inside when it is rolled up. Does not seal. What is the best way to remove the Rear Interior Side Panel? Need to remove so I can look at the window crank.
  5. Restoration Corner
    I am needing to source a pair of seals for a set of 68 rear lights, I have a pair I bought from Ricks but I am not happy about using them because they are not brilliant quality, the fit is "floppy" and the cut is Sloppy". When the lamps are in the rear panel there is rubber sticking out in some...
  6. Transmission & Driveline
    My car has an original open rear, and I'm looking to go posi because it just fries the right tire when I try to launch. So my question is, what rears will swap into this car without modification, besides the obvious, another one from a 1st gen Camaro. Found one reasonable from a 79 Trans Am...
  7. Brakes, Suspension & Steering
    Ok, so I am not a car guy (never been in an auto shop class) but I am turning into one. I am 43 and loving this project. :) I am doing a jack stand restore on my wife’s first car. It is a 68 plain Jane 327, power glide, single leaf (Do not know much more that that). All is going well since it...
  8. Brakes, Suspension & Steering
    Was at the junkyard and saw a set of LS1 rear brakes. Does anyone know if the parking brake from the LS1 can work with the C5 rear rotors and calipers?
  9. What's it worth?
    Hello All, I was just wondering how much a 1969 rear fold down seat or some 202 heads would be going for these days.
  10. What's it worth?
    Hello All, I was just wondering how much a 1969 rear fold down seat would be going for these days.
  11. Body Shop
    I was wondering what you thought the proper order of operation should be on my car. It has some rust in the typical places and so I bought all new sheet metal to replace it all. I figure, if I am wanting a near-perfect and rust free car, I should replace all the metal and start fresh instead...
  12. Body Shop
    Ok guys! This body story is worth sharing. So I decided to buy a welder and start on my 69 Camaro Coupe restoration. Great! I started by removing the rear quarter on the pass side. Lo and behold-- there was the full original rear quarter underneath it!:confused: The previous owner (I...
  13. Body Shop
    I am going to attempt to remove my old rear quarters (which are new) --I'll explain later... I have a 1969 Camaro Coupe with two sets of rear quarters on it. Yes--two:confused: I have no idea what the previous owner was thinking, but I would like to remove "them all" and start fresh. I think...
1-13 of 13 Results
Top