Team Camaro Tech banner

solenoid

  1. Remote solenoid switch not activating?

    Electrical & Wiring
    Hi, I installed a solenoid switch to address my heat soak issues. I have everything wired up but when I turn the key the starter will not engage. I had a friend turn the key to start position while I put a test light to the solenoid. I have power from the battery to the switch, purple wire...
  2. 1967 Camaro run on problem

    Troubleshooting
    Hi, I've come 360 degrees from when this problem began. To begin with, I experienced my car not wanting to turn off when the ignition was switched into the off position. Like many others have had problems with, I could pull the key out and walk away while the car kept idleing perfectly. I...
  3. WTB Idle Kicker

    Forum Classifieds
    Does anyone have or know where I can find an idle kicker for a first gen? Its a small electric actuator that mounts on the carb and kicks up the idle when the air conditioner is turned on. Thanks,
  4. 327 to 396 - 68 Camaro - Kickdown Question

    Engine
    Hello Group, I am finishing up my 68 Camaro resto and put a TH400 tranny in. The original was a 327 with a Powerglide. Here is my question--what components do I need to install the electronic kick down. I have read nearly every post here and searched the classic resto parts sites (Ricks...
  5. More help needed wiring ignition switch/solenoid/starter etc.

    Electrical & Wiring
    Well, I'm finally almost ready to hear my new 383 run in my convertible for the first time. I just need to sort out some wiring issues. A few months ago, with the help from others on this forum (thanks again), I came up with the schematic below. So in theory, this should work out safely, but...
Top