Team Camaro Tech banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Transmission & Driveline
    The drive gear inside my Muncie for the speedometer just seems to spin on the shaft when I stick a finger inside where the driven gear is installed. I'm fairly sure it's supposed to be pressed onto the main shaft, correct? If so, would I need to remove the transmission to fix this? ...or can I...
  2. Transmission & Driveline
    Hello Just recently did this. Lots of scattered posts on here that talk about the subject of matching and sizing gears up but nothing with pictures that explains how to handle a drive gear change. Hope this helps someone. First jack up the rear of the car and remove the drive shaft...
  3. Camaro Tech
    Does anyone have a suggestion for how to repair/replace the plastic piece which holds the odometer tangs in place? I was cleaning one with a brush, and broke the old plastic.. so now one of the digits is 'freewheeling'. Can these be purchased anywhere? If not, any suggestions for 'making one'?
  4. Transmission & Driveline
    I have a 700R4 with 3.73 gear and 27.25 tire, original speedometer in a 68. I was registering over 20MPH off @ 70MPH. (between 90& 100) I checked with a vendor that suggested a 17 drive and a 45 driven. I installed this setup and now I am 6MPH off @ 50-60. I could also have used a 15/41 but the...
  5. Forum Classifieds
    I need the ones that run from trans to speedometer -- not the part that secures the cable to the speedometer. OEM or repops are fine. Thanks!
  6. Transmission & Driveline
    PO installed AutoMeter gauges. I removed the AutoMeter speedo wiring and this nut/attachment is what I'm left with. In returning to an OEM set up (powerglide), do I just remove the nut/attachment that's there, and replace it with a bullet set up like this...
  7. Restoration Corner
    Just looking at my first posts before I bought the car this summer. It's like reading the words of a naive 16 year-old. As a remorseful man once said, "If I knew then what I know now..." It's been painful occasionally (finding rust spots here and there and a welding patches), but FUN (turning...
  8. Troubleshooting
    I have just bought a 92 Camaro and the only major problem was the speedometer. I have replaces the speed sensor, and i even bought a new cluster and the new cluster did not work either...... :(WHAT SHOULD I DO NOW??!!!:confused::confused::confused:
1-8 of 8 Results