Team Camaro Tech banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am replacing the right side frame rail on my 69 Camaro. How and where would I weld in tubing to keep the Car from moving.I am thinking I can use the Fisher Measurements to be sure of proper install.Any input on this repair is Appreciated, Thanks.
 

·
Premium Member
Joined
·
5,644 Posts
I did a partial on mine and I got the rear bushing moved forward some how but the width was correct. I believe I just measured from one side to the other and matched it when going back. Keep in mind the front of my repair was just over the center of the axle tube and I had the spot on the tail pan where the old mounted.

Jeff
 
1 - 2 of 2 Posts
Top