Team Camaro Tech banner

1 - 14 of 14 Posts

·
Registered
Joined
·
1,444 Posts
Discussion Starter #1
Can someone provide me with some location dimensions of a guage pack for a 67 console? I have the cutout laid out, but I just want to be sure. I am mainly looking for the very front dimension, width of cutout and length. The holes are obvious to me. I would appreciate any help guys. Thanks
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #2
Guys, can someone send me the cutout size of the guage hole?

Scot
 

·
Registered
Joined
·
3,677 Posts
Not sure that I understand....Do you want the hole in the console or the holes for each of the gauges?

Mine is sitting on the workbench, so I can get you whatever dimensions that you want.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #4
The hole size for the guage housing. Also what is the dimensions on where it is positioned on the front of the console.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #6
Arizona time, same as my time. hehe. Here in Nevada. Paul, you know of some places where I could get a couple of doors so I can cut some patches out of?
 

·
Registered
Joined
·
3,677 Posts
Sorry, I got tied up and now I can't ftp my pictures up....I'm not sure what's going on?!?!?

No, I don't know of any doors. I can ask around though. What parts of the door do you need?
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #8
I'm looking for drivers/passenger front lower and rear lower sections.

Paul would you mind a phone call? Email me at [email protected] if you don't mind me calling you.

Scot
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #10
No Paul, I haven't
 

·
Registered
Joined
·
3,677 Posts
I sent an email from my [email protected] address to my yahoo address and it ended up in the "Bulk" area. I guess that yahoo thinks that my emails are spam. I also sent you an email from my yahoo address which should have gotten through to you.... Why does such a simple thing like sending an email have to be so complex?!?! :mad:


Here are the pics...

http://www.stratagaz.com/ConsoleGaugeOpening01.jpg

http://www.stratagaz.com/ConsoleGaugeOpening02.jpg

http://www.stratagaz.com/ConsoleGaugeOpening03.jpg

http://www.stratagaz.com/ConsoleGaugeOpening04.jpg
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #12
Just a follow up for those of you who don't have the measurements of how to locate the 1967 console guages, I have all the measurements now. I thank those of you who responded with your help. THANKS ALOT!!!
 

·
Registered
Joined
·
847 Posts
There is a guy on ebay selling the "pattern" to this set up you're talking about. Apparently you just lay it over your console & it shows you exactly where to cut for a factory appearance.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter #14
I looked at his pattern. Really simple huh? But, to be exact, the measurements from an original console was in order for my car. PaulM and Jerry Ladner get all the kudos. Thanks guys. By the way, the one on Epay doesn't have locating marks for the console. It only has the size of the cutout. Thats it.

Scot
 
1 - 14 of 14 Posts
Top