Team Camaro Tech banner

1 - 5 of 5 Posts

·
Registered
Joined
·
565 Posts
Discussion Starter #1
I recently replaced my heater controls on my 69 Camaro. The control cables connect to the heater controls with a small metal clip holding the cable to the control arms. When I removed the clips they broke.
Does anyone know where I can get these clips or a substitute for them?

They are small flat, round pieces of metal with a whole in the middle and small slits in them. They just snap over the control arm.
Thanks,

------------------
 

·
Registered
Joined
·
145 Posts
You might try a hardware store, or Lowes or Home Depot. I have found the hardware store usually has most any type of fastners. If they dont have exactly what you need, you can usually find something that will work.
 

·
Premium Member
Joined
·
7,728 Posts
Those are GM #381700 speed nuts - Rick's has them, 4 to a pack, their #HW-35.

------------------
JohnZ
'69 Z28 Fathom Green
 

·
Registered
Joined
·
565 Posts
Discussion Starter #4
JohnZ, Perfect information. Rick's has exactly what I was looking for.

Rick's web site is at: http://www.firstgen.com/

------------------
 

·
Registered
Joined
·
867 Posts
I also replaced my heater control a couple of months ago. Those little speed nuts were a pain. I found them at a local Paint/Glass supply shop. Make sure you get the correct size.

------------------
'69 Z11 Pace Car, 350/4 speed, manual top, console w/gauges, tilt rosewood wheel, AM radio
 
1 - 5 of 5 Posts
Top