Team Camaro Tech banner
1 - 3 of 3 Posts

·
Registered
Joined
·
652 Posts
Discussion Starter · #1 · (Edited)
1. The kit comes with a dished backing plate. The instructions just say to mount it but don't mention which side should face out and the part does not identify either.

2. The rear rotors have 9/16 holes and my stock axles have 7/16 studs.
That's a 1/4" difference and doesn't seem right.

3. does anyone have pictures with position of the rear caliper mounted? Other than mounting it upside down I keep getting interference with either the shock or the leaf springs.

I know lots a folks installed this kit so I hope they will chime in.



Thanks again.


Rich
 

·
Registered
Joined
·
652 Posts
Discussion Starter · #5 ·
Stopped by Matt's Classic Bowties to see if they could help me figure out the problem with my brakes and it seems that Baer boxed up the wrong brake kit.
The part number on the box was correct but had different year brakes inside.
Kim called Baer and had them send new brakes immediatley.

You can't beat the service Matt and Kim provide. :thumbsup:


Rich
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top