Team Camaro Tech banner
1 - 2 of 2 Posts

296 Posts
Discussion Starter · #1 ·
I know for best results the fan should be half in & out of the shroud for best flow. My question is , was a factory 396/427 Thermal clutch set up with? A odd ball spacer, or is standard like a 1in or 2in ect. If it is a odd ball spacer I'm going for a correct set up, any pointers on where I could find the correct size would be helpful.

My thoughts on restoration, Help Freinds Who help you. To many help me & me only's in the World, lol.

69-RS/SS 540/ 635hp 4spd Wolf in sheeps stickers, lol
Look's just like a factory 427 Mostly Show but it will go as well.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.