Team Camaro Tech banner

1 - 3 of 3 Posts

·
Registered
Joined
·
91 Posts
Discussion Starter #1
With everyone's experience, what are a few of the best company's out there as far as reproduction quality and pricing for 1rst generation parts...top to bottom...thanks.

------------------
1968 Camaro, 383 Stroker, 450hp @5400rpm, 3.73 10-bolt
Lots of body and interior work to do now and it's all
new to me, lots of advice to ask for, thanks in advance
 

·
Registered
Joined
·
297 Posts
2zmax - If you do a search in the "General Tech" you can probably find alot of info on vendors. It gets asked quite often. Our site sponser, Ground-Up is a good place to start. You can also check out NPD(National Parts Depot), Rick's First generation, Year One and Firewheel Classics. For the most part they pretty much all use the same manufacturers. Some offer kits, volume discounts, free shipping, etc. What I did was got as many catalogues as I could and then made a list of what I needed. I then priced out each item and compared discounts and shipping charges.

Hope this helps.
 

·
Registered
Joined
·
91 Posts
Discussion Starter #3
Thanks...Ground up. Have to get that. I have the others you were mentioning and your right, the prices vary alot. No one seems to have all the best prices but I was mainly interested in quality also. Seems the search option will work wonders in this site. I am sure there is a ton of info on just about everything in here. Thanks again...
 
1 - 3 of 3 Posts
Top