Team Camaro Tech banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have 68 Camaro RS with a small block. I bought a set of Borla stainless headers 2 years ago. I'm finally at the point where I'm putting them on the car. (You know how long "frame-off" restos can be!!) Anyway, the driver side fits good, but the passenger side actually hits the floorboard. I called Borla and talked to a service rep. He was very helpful and sent me another set to try but the same problem exists. What's the deal?? The old rusted up Hookers fit fine. Anyone else had any experience with the Borla headers on early Camaros???? I'm starting to go nuts! Thanks for the ear,TZ.
 

·
Moderator
Joined
·
10,142 Posts
TZ,
Hit the search link on the upper right corner of this page and search the archives in this section, and the performance section. Search on "Borla", also "headers".
You might also try the engine and drivetrain section as I think I saw a post on it there too.
David

------------------
Check my web page for First Gen Camaro suspension info:
David's Motorsports page
First Gen Suspension Page
67 RS 327
69 Camaro Vintage Racer
65 Lola T-70 Chev 350 Can-Am Vintage Racer
 

·
Moderator
Joined
·
10,142 Posts
1 - 3 of 3 Posts
Top