Team Camaro Tech banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
3,820 Posts
Discussion Starter · #1 ·
Hello...Whats a good method to use to clean a GM distributor housing? I just picked up a numbers correct one for my car but is horrible looking. Anybody?


Thanks,
Gary
 

·
Super Moderator
Joined
·
33,211 Posts
Clean it with lacquer thinner to remove the oils and grease and dirt.

Then, have it PBM'd, Plastic Blast Media, at about 30 psi to etch the alum housing. Don't use sand blast!

Everett 68/350/PG/11.90/115mph
 

·
Registered
Joined
·
622 Posts
I got some wire wheel cleaner that cleans the **** out of aluminum. It mayde my old doug nash trans look new...

wear saftey glasses and gloves.
I know you allready have a mother, but be carefull,
John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top