Team Camaro Tech banner

1 - 3 of 3 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter #1
Need to drill and tap my 400 sb for the clutch pivot ball. There are two undrilled/untapped bosses on the side of this engine. One is above the oil filter and the other is in front of this location by 3-5 inches. Which is the proper location for a small block in a '69 chassis?
 

·
Registered
Joined
·
76 Posts
See the reply to your post in the Engine & Drivetrain section.
 
1 - 3 of 3 Posts
Top