Team Camaro Tech banner

1 - 6 of 6 Posts

·
Premium Member
Tim - The Northwest 1969 Camaro
Joined
·
1,008 Posts
Discussion Starter #1
Does anyone know how you can attach a mandrel bent tube to rubber ends as shown in the photo? I have the ability to bend the tubing but not clear on how this can be done. Doesn't look like they use the shrink to fits so just curious. This is one of DSE's builds:
 

Attachments

·
Premium Member
Joined
·
4,571 Posts

·
Moderator
Joined
·
14,116 Posts
  • Like
Reactions: Just 1 More

·
Premium Member
Tim - The Northwest 1969 Camaro
Joined
·
1,008 Posts
Discussion Starter #5
They may be using the Gates Powergrip hose clamps. I use them on all of my builds.

https://www.amazon.com/Gates-32925-...t=&hvlocphy=9030743&hvtargid=pla-570331448525
That's what I was referring to with my term "shrink to fits". I am assuming this as well but from the photo it sure doesn't look like it but was mostly just curious. I don't think I will go to the trouble but when I was looking closely at the example I couldn't figure out what they were doing. Maybe connecting it with gates then sliding other hose over the ends for the appearance?
 

·
Registered
Joined
·
111 Posts
Maybe the car had not yet been started in this pic? Car was not finished at this time would be my guess...

Sent from my SM-G965U using Tapatalk
 
1 - 6 of 6 Posts
Top