Team Camaro Tech banner

Dual Exhaust bracket hanger for an SS

1174 Views 1 Reply 2 Participants Last post by  1967 Panther
I have read a number of posts about a dual exhaust bracket hanger being welded to the frame to help identify an SS. What does this thing look like? Is it a thin piece of metal or is it pretty stout? My 68 SS has 2 pieces welded in about the right location, but they are probably 3/8" thick steel and it looks pretty much "not factory". They look pretty rough, like they were cut with a torch. Would someone have welded these in to stiffen the frame where it makes its bend around the axle?
1 - 2 of 2 Posts
68's don't have them at's only on 69's..for 68 they used compression nut.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.