1 - 6 of 6 Posts
Found one at harbor frieght. 30 bucks.
What type of flange tool? Sheet metal?
If you want cheap, you can always try Harbor Freight. Most of the tools I get from them are OK but not for everyday use. I bought an air powered flange tool from them and it works well enough.
It's on sale right now:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=41696
If you want cheap, you can always try Harbor Freight. Most of the tools I get from them are OK but not for everyday use. I bought an air powered flange tool from them and it works well enough.
It's on sale right now:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=41696
Chuck, that's the one I just ordered. I'm in the middle of putting on 80% quaters. I hope this work's.
Good luck Marcus. I've used mine mostly for punching holes. All of the work I've done has been with butt welds but it looks like the flange will work.
You're better off butt welding with a backer strip. At least that's my opinion. Less chance of ghost lines.
1 - 6 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Join the discussion
Team Camaro Tech
A forum community dedicated to 1st generation Chevy Camaros owners and enthusiasts. Come join the discussion about performance, builds, restoration, modifications, classifieds, troubleshooting, reviews, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
Join now to ask and comment!