Team Camaro Tech banner

1 - 7 of 7 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
im going to be removing my sub frame sometime during the week. this is my first time doing this and was was looking for any last minute do's and dont's.

its a 68.
 

·
Welcome Back - Senior Tech
Joined
·
890 Posts
Its relatively easy. I had never done it before and I finished taking the front clip off in about 2 hours. My suggestion would be to pull the front clip in one piece, that way you don't have to worry so much about lining everything back up later.
 

·
Banned
Joined
·
21,341 Posts
Leave your tires on it, jack the body up and use a floorjack back at the tranny mount and CAREFULLY roll her right out!!

pdq67
 

·
Welcome Back - Senior Tech
Joined
·
890 Posts
Ah my bad. I didn't realize you were that far along. When I removed mine I left all of it together. I put a dolley underneath the transmission, cut the bolts (they were too rusty) and tie a rope to the front. I then had someone steady the back while I yanked it out.
 
1 - 7 of 7 Posts
Top