Team Camaro Tech banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi guys,This site rocks!:beers: Just wondering if one of you fine gentlemen could run thier desktop dyno for my gen6 502? I have a crane hyd roller part#168721 in mind for this build, and would like to know how its going to run.Here is my info:GEN IV 502 BORE=4.5 STROKE=4.0 RODS=6.135 CR=8.5-8.75 CH=1.645 HEADS=RECT 325CC CHAMBER=118CC 2.19 1.88 VALVES POCKET PORTED WITH RACE FLOW 3/8 VALVES INTAKE IS A DUALPLANE HIGHRISE AND 1410 MARINE 750 CFM.CAM INFO AS FOLLOWS:LIFT=553 INT 564 EX [email protected]=INT OPEN 27 CLOSES 69 276 DEGREES EX OPEN 74 CLOSES 28 282 DEGREES [email protected]=INT OPEN 0 CLOSES 34 214 DEGREES EX OPEN 47 CLOSE 7 220 DEGREES LSA =112 EFS=3.76 DCR=8.05 HOPE YOU GUYS CAN HELP ME ?THANKS.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top