Team Camaro Tech banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
3,815 Posts
Discussion Starter #1
I have a balancer 6 3/4" x 1 1/8", not sure of that last number now, with 2221 and what looks to have either G & F OR G 3 F on one of it's legs. The hub legs go all the way to the inside of the balance weight. Timing mark is not in line with the key way, but off set to the left if you are looking at it the front of hub.

Any ideas?
 

·
Premium Member
Joined
·
10,082 Posts
The damper for your 302 should be an 8" diameter unit. #7708 factory unit has the 3 spokes from the center to the inside edge of the ring. The service 7708 does not have the spokes.
 

·
Premium Member
Joined
·
3,815 Posts
Discussion Starter #5
The damper for your 302 should be an 8" diameter unit. #7708 factory unit has the 3 spokes from the center to the inside edge of the ring. The service 7708 does not have the spokes.
It's for another engine. Goes to my 71 CGC 350 engine.
 

·
Premium Member
Joined
·
1,441 Posts
While doing some research for a new balancer for my 350, I came across the specs for the 302. It does require an 8" balancer 1 3/4" thick. This is according to "The definitive 1969 camaro Z/28-SS396 fact book" by Jerry MacNeish. In his book he lists the correct part number as 3947708. Hope that helps.
 
1 - 6 of 6 Posts
Top