Team Camaro Tech banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10,515 Posts
I took a slightly different approach - a few years before the Hotchkis piece was available.

I made my own X-brace. A couple of 2" x 3" pieces of angle iron and a piece of 1/4" plate. I made it so that the brace goes up into the tunnnel, and the exhaust system hangs below it like it would on any coupe. Works great and cost about $10 to make. It only utilizes the front two bolt holes on each side. I used the original X-brace as a template.





 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top