Team Camaro Tech banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,821 Posts
Discussion Starter #1
I'm in the process of installing a Hyperspark Ignition on my SBC. I'm looking to put the CDI box near where the battery was located under the hood. The Hyperspark coil is HUGE and I'd rather not ugly up my firewall by mounting it there. My Terminator ECU is in the glove box. There's plenty of room down by the CDI box to mount the coil, but that would make for a pretty long coil wire. Does anyone see a problem having a long coil wire or have a better solution on where to mount this ugly coil?

 

·
Premium Member
Joined
·
1,808 Posts
I understand your problem.
My glove box area is full, HP ECU, MSD 6 AL,blaster coil.

I bought a MSD HVC-2 Coil a few weeks ago, that is BIG ! I sent it back. no way I was going to mount that thing on my firewall for the same reason I didn't want an MSD box there, looks too cluttered to me. I couldn't figure out a clean place to fit it without a looong wire to the distributor.
 
1 - 2 of 2 Posts
Top