Team Camaro Tech banner

1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Hey all. Did a search and looked at the threads from 02 and 01 on converting 4th gen seats into a 1st gen ride. Wanted to see if there were any new ideas or suggestions on this convert. Thanks, Rob
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Hey DJD, thanks for the tip. Did a search using seat swap and got lots of ideas. Rob
 

·
Registered
Joined
·
127 Posts
RGJ, I am in the middle of doing a swap into my 69, got a set of buckets out of a 95 Firebird for 50 bucks, had to fab some Z brkts for rear mounting and reposition the front seat track attaching points but the do look good in the car and are so much more comfortable. I believe any late F body seat (95 on) will all fit with a little fabbing, and look great. I looked in the Camaro Performer mag and saw some pictures of late F body seats in 1st gens then searched Ebay final went to locale wrecking yard and scored some nice seats, now laying out about $300 to have done to match orginal look.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #5
Hey Clash, hope you can add some pictures of the install when your finished. Are you going to have power seats?? Thanks
 

·
Registered
Joined
·
127 Posts
No power, Drivers seat is 3 way, will post when installed
 
1 - 6 of 6 Posts
Top