Team Camaro Tech banner
1 - 3 of 3 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter · #1 ·
I just bought a 1967 327 4 speed Camaro... and found out the transmission locks up when you put it in reverse. It rolls fine in all the other gears.

Would I need to pull the transmission out and rebuild it, or what could be wrong?

Thanks!
 

·
Registered
1969 Camaro
Joined
·
545 Posts
Have you gotten under the car and looked at the linkage .. it may be binding .. there should be a threw hole to stick a screw driver in the shifter linkage to make sure all the gears line up when in neutral
 

·
Registered
Joined
·
601 Posts
if you start it up and got it in neutral it is fine and all other gears work but binds up in reverse. when in neutral and got clutch out it dont move anywhere. sounds like either a couple of problems when you go to reverse it grabs first gear also need some one inside and put it into reverse while someone looks underneath to see if 2 gears go into at once . only 1 rod should move not 2 rods.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top