Team Camaro Tech banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I have been trying to figure out the easiest way to get the lower door molding off of the outside of my 67 rs. There is a little slot at the bottom and that is all that i can see, but i don't want to mess it up. I was also thinking that i might have to take the inside door panels off. I would appreciate some advice .

Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top