Team Camaro Tech banner

1 - 9 of 9 Posts

·
Premium Member
Joined
·
5,230 Posts
Discussion Starter #1
I'm using an Entropy LS Swap radiator with the fill cap on the drivers side. I haven't installed the fender supports yet but it sure looks like they will NOT clear the radiator cap on the drivers side. ( I don't have the supports to test fit). Anyone have this set-up ??? Fesler has curved fender supports but geez, they are 200.00 bucks. I'm not looking to spend 200.00 on fender supports right now LOL.
 

·
Premium Member
Joined
·
5,230 Posts
Discussion Starter #3
I have the same setup with the fesler curved bars. Works well.
I had to trim my Roto Fab box too. Again 200.00 for fender supports ugh ......
 

·
Premium Member
Joined
·
4,635 Posts
Looking at the above pic it looks like straight bars would clear.

Don
 

·
Premium Member
Joined
·
5,230 Posts
Discussion Starter #7 (Edited)
Here is my set-up. I placed a straight piece of tubing for reference. The stock fender supports may just make it.

UPDATE: Bit the Bullet LOL, Ordered from JEGS. SPRING30 SALE******
 

Attachments

  • Like
Reactions: 130fe

·
Gold Lifetime Member
Joined
·
1,649 Posts
Yeah, it’s a tight fit LOL. Sales always make the purchases easier.
 
  • Like
Reactions: DT
1 - 9 of 9 Posts
Top