Team Camaro Tech banner
1 - 1 of 1 Posts

· Registered
Joined
·
331 Posts
when I had to do the similar thing, I cut the vynal outer part first with an hobby knife (exacto knife). For the thicker rear material I used an utility knife and slowly keeped going around the circuilar diamater until it cut thru. Take your time and it should come out great.

You will want to put some spray adhesive glue under the vynal edge of the reaming materal you are cutting out to keep it from moving around.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top