Team Camaro Tech banner
1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I joined this site because I know there are many knowledgble gals and guys out there with lots of camaro experience.
I am currently knee deep in ground up camaro restoration/upgrade. The car has been completely striped and is in the primer stage. My next goal is to weld in a roll bar and subframe connectors. My main concern is selecting a pre-bent set up that will allow interior panels. Anyone done anything like this...The camaro is a 67. Thanks.
 

·
Registered
Joined
·
3,064 Posts
Welcome to the Team Robert! :waving:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top