[Rich-Allen]

got the UCA and LCA back on but when installing the QA1 coil overs I don't get how the thrust bearing kit sits on the shock.

Right now I have the two adjusters on the bottom and then big flat washer/ Bearing / Big Flat washer / Spring

It's just doesn't look right when the spring sits on top of the thrust bearing washers.
because the spring isn't flat all the way around it makes the washer sit unevenly. Its hard to explain unless you have done this before.
Am I missing something?

If you guys need a picture I can take one.


Thanks.

 

[Rich-Allen]

Does it go on the shock side? I think the spring is flat on that side right? I don't think it's intended for the spring to rotate in the pocket, just the adjuster to rotate on the bottom of the spring in the direction desired. I don't know what you looking at but have some idea.

Simple: Put the washer/spacer/bearing between the shock adjuster and the spring. The spring as far I can figure should be flat there.

Joe

Joe, that's exactly how I have it but the spring isn't exactly flat all the way around which causes the thrust washer to sit kinda crooked on the adjuster.

 

[Rich-Allen]

took a couple pictures to better illustrate

 

[Rich-Allen]

Thank you for the reply's. :thumbsup:

Now I can continue putting this back together.


Rich