Team Camaro Tech banner

1 - 3 of 3 Posts

·
Registered
Joined
·
325 Posts
Discussion Starter #1
Hey guys,

I took my old intake and 2 barrel carb off my 327 to put on an Edelbrock Performer RPM q-jet intake and a 4 barrel re-done rochester q-jet.
I have looked everywhere for detailed photos of what goes where, and cant find anything...let alone for the 327.
Does anyone know of a good link that has detailed pictures of what hoses and lines go where on the 4 barrel q-jet for a 327?
The 2 barrel is completely different, and I did make note of where everything was on the old 2 barrel, but the 4 barrel is a whole 'nother beast, and I dont want to mess anything up.
Thanks for the help on this!
 

·
Super Moderator
Joined
·
32,606 Posts
Re: need help with 4 barrel quadrajet installation on a 327

PCV hose is the big nipple.
Dist adv is pass side front nipple.
Choke unloader is nipple next to it, pass side.
Full time vacuum is lower drvr side front nipple.
 

·
Registered
Joined
·
325 Posts
Discussion Starter #3
Re: need help with 4 barrel quadrajet installation on a 327

PCV hose is the big nipple.
Dist adv is pass side front nipple.
Choke unloader is nipple next to it, pass side.
Full time vacuum is lower drvr side front nipple.
OK...thanks for the info. Hopefully i can figure it out...if not, i can always buy a book.
Does anyone have any pictures they could take of their 4 barrel q-jet on an edelbrock intake rpm q-jet on their 327 to show where everything hooks up?
Thanks for the help with this!
 
1 - 3 of 3 Posts
Top