Team Camaro Tech banner
1 - 2 of 2 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I recently removed my drip rail molding for a repaint. Underneath, I found the 1” body molding connector on each side. CI description implies these are only used on cars without SS drip molding. Should these be removed to allow SS molding to fit better? Will they easily pop off or are they welded on? Thanks.

Font Newspaper Parallel Rectangle Publication
 

· Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
How did you remove your drip rail without removing these connectors?

The drip rail with the SS trim cover, does not use that connector.

thanks for your reply. I did not remove the drip rail. Only the SS drip rail molding was removed. I’ll try to gently pry off the connector so the new SS molding will go on easier.
 
1 - 2 of 2 Posts
Top