Team Camaro Tech banner

1 - 4 of 4 Posts

·
Registered
Joined
·
648 Posts
Discussion Starter #1
Hey guys, I want to get this bracket anodized and I need to remove the steel stud first. What would be a good way to remove it? I don't see any lock tite in the threads but when I put two nuts on the stud and lock them together and try to back it out, it seems to not want to back out. I haven't tried to put it in a vise and put alot force on it to back it yet. Would heating the bracket up be a good idea? Looking for any ideas you guys have.



Thanks,
 

·
Registered
Joined
·
648 Posts
Discussion Starter #2 (Edited)
Hey guys, I want to get this bracket anodized and I need to remove the steel stud first. What would be a good way to remove it? I don't see any lock tite in the threads but when I put two nuts on the stud and lock them together and try to back it out, it seems to not want to back out. I haven't tried to put it in a vise and put alot force on it to back it yet. Would heating the bracket up be a good idea? Looking for any ideas you guys have.



Thanks,
Here is a picture of the bracket
 

·
Super Moderator
Joined
·
32,355 Posts
As Todd suggests, looks like a press fit.
Leave them be and tape them up before anodizing.
 
1 - 4 of 4 Posts
Top