Team Camaro Tech banner
1 - 7 of 7 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I bought this subframe and was told it was for a 69. It seems to measure out ok but the rad support holes are small(about 7/8" i diameter). Does anyone know the explanation?
Apparently these holes should be about 1.25 inches. The solid bushings i got from globaltech won't fit in the holes and the guy there says i may have a 70's subframe.
Like i said it seems to measure out ok(am taking it off this weekend to measure properly).
 

·
Registered
Joined
·
1,015 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #4 ·
Gotcha , but what about the slop in the 7/8" hole where the bolt goes through the subframe? Is that for adjustment?
 

·
Registered
Joined
·
1,015 Posts

·
Premium Member
Joined
·
7,728 Posts
The oversize hole in the subframe is designed that way for adjustment; fore-aft for fender-to-door fit, cross-car to be able to create a square hood opening.

------------------
JohnZ
'69 Z28 Fathom Green
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top