Team Camaro Tech banner

1 - 15 of 15 Posts

·
Registered
Joined
·
219 Posts
Discussion Starter #1
Can someone tell me who makes a throttle rod to throttle cable conversion kit? I'd like to convert to a cable setup. I have a '68 with a 327 and Edelbrock #1406 carb 600 cfm.

Thanks
 

·
Premium Member
Joined
·
4,765 Posts
You could probably use the 6 cylinder pedal. I’ve done it with LS1 conversions.

Don
 
  • Like
Reactions: Troutslayer

·
Premium Member
Joined
·
3,907 Posts
Lokar has a cable pedal system. Kind of hard to change with motor in the car but can be done. Replaces the whole pedal assembly.
 

·
Registered
Joined
·
311 Posts
I think they went to the cable sometime in the early 70s on most GM cars. You might cruise the junk yards and get a complete setup (cable, bell crank, pedal and all), but it might be easier if you just order the Lokar system. You are in tight work space either way.
 

·
Registered
Joined
·
219 Posts
Discussion Starter #6
Thanks everyone. Much appreciated!
 

·
Registered
Joined
·
426 Posts
I have a 67 with a 327 and Holley, and the factory rod setup is still intact. The solid rod I have is adjustable, so perhaps this is the solution if you decided to keep a solid rod arrangement.
 
  • Like
Reactions: Troutslayer

·
Premium Member
Joined
·
1,979 Posts
X2 - super easy set-up
 
  • Like
Reactions: Troutslayer

·
Registered
Joined
·
219 Posts
Discussion Starter #11
Thanks everyone. I'll check out the Lokar cable system.
 

·
Premium Member
Joined
·
4,765 Posts
You will need the Lokar cable even with the factory six cylinder pedal. The six cylinder pedal will give you a stock appearance.

Don
 
  • Like
Reactions: Troutslayer

·
Premium Member
Joined
·
4,765 Posts
  • Like
Reactions: Troutslayer
1 - 15 of 15 Posts
Top