Team Camaro Tech banner
1 - 3 of 3 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter · #1 ·
When I installed my crate motor I didn't think about pulling the 5/16" square headed plug out of the oil sender hole by the distributor. When I tried to get it out I rounded off the square plug. There is no room to get a Vice Grip on it. How would you get it out? By the way I did get it out.
 

·
Registered
Joined
·
1,693 Posts
If the square head was 1/4", you could use a 1/4" extention upside down and turn the extention with an open end wrench.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top