Team Camaro Tech banner
1 - 3 of 3 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter · #1 ·
I replaced the Muncie in my '69 Z28 with an early '70s Muncie M21 (fine spline) . Unfortunately the original shifter mounting plate from the '69 will not mount on the later model trans tail shaft. The 70's Muncie tail shaft is GM# 3978764 . I need is a mounting plate that will correctly locate the shifter in my center console. I did some research and came up with this mounting plate. Anyone else had to do this work-around?

70-71 Hurst Shifter Mounting Bracket
Composite material Auto part Metal Household hardware Carmine
 

·
Registered
Joined
·
151 Posts
Discussion Starter · #4 ·
Don't suppose you could get a pre-1970 M22 tailshaft?
Cangialosi
I did consider that but the trans is already mounted in the car and I didnt want to pull it apart. I found a bracket that Paul Cangialosi , 5speeds.com makes that is designed specifically for my situation. It needs to be used with a spacer ring. It just arrived and I will be mounting it later this week. Will update after the installation
 
1 - 3 of 3 Posts
Top