Team Camaro Tech banner
1 - 13 of 13 Posts
Neat car though but yes dealer kills the interest for me as well.
 
Nice car, i have seen it long ago probably before restoration. Go to the back end of the pictures. Did 67 Z come with mono rear springs? Does have 12 bolt.
 
….and none came with Z badges.

Ev, what do ya suppose causes the rear bumper to droop in the side views ? Is it the bumper itself, the mounting brackets or is it misplaced holes in repro quarter panels ?
A peeve of mine that shows up way too often on 67/8's !:cautious:
 
I think I recognize the car. Is this the one with the fake trim tag? There is a genuine 67 Z out there that someone bungled during resto, putting the Z/28 badges on the front fenders and putting on a fake trim tag. Not sure what happened to the original trim tag; can't remember the story.
 
Discussion starter · #10 ·
….and none came with Z badges.

Ev, what do ya suppose causes the rear bumper to droop in the side views ? Is it the bumper itself, the mounting brackets or is it misplaced holes in repro quarter panels ?
A peeve of mine that shows up way too often on 67/8's !:cautious:
Gar, I have seen this 'angled rear bumper corners' several times as well. This may be due to the qtr panel holes in wrong place, rear brackets by license plate wrong or not adjusted correctly. One would think in adding washers between bracket and bumper for straightening the corners out, at least I would.
 
Missed that bumper the first time.
Also isn't part of the grill missing?
I think the grill is all there, but has been painted (too much gloss) and the front edge of lower piece wasn't masked off. Should be bright anodized aluminum showing, but is painted black.

Same car Lynn was referring to....


Funny, those photos taken back in '90 show the grill the same way...
 
1 - 13 of 13 Posts