[zuma]

No... just evac your system, and then open your valves, then check your superheat...(there is a lot more to it that I haven't touched on) but you might call someone out to check it out if you are not sure...If it is overcharged you might trip the high head cut out on a warm day or worse...Just make sure when you silver solder your line set on, first remove your needle valves or you will melt them (reinstall new ones)... also wrap your valves and evaporator coil's thermal expansion valve with a cold wet rag...this will protect the valves from your heat....Hope this might help...good luck...

 

[zuma]

Thanks for the responce I call the manufacturer todat and they said it did not matter that it has a suction line accumulator on it.This unit line set is flare joints...Thanks again..This was a test only a test....

Good luck with it Dave....