[z28rich]

I have a car that has a EY spring code and the 6320 is tha moog replacement.anyone running this.car is still stock,no p/s. I tried an eaton MC1228 and its too high

 

[myty]

I ordered those same 6320 springs, and the shop hasnt installed them yet but I will get back to you. Trying for the middle of the week, Gary

 

[tdb11]

I have a RS Z and I am almost certain I put 6320's in. I'll look through my paperwork....

 

[tdb11]

Rich,

Can't seem to locate the info on what I put in. I'm certain it was either the 6320 or the 6308...it was 3 years ago

 

[tdb11]

Ah ha! They were Moog 6320's. Found my original link here, see: http://www.camaros.net/forums/showthread.php?t=131214

Let me see if I can post a picture or two for you.
Tom

 

[tdb11]

Richard, See if you can open this. I'm new to Flicker, so I hope it works. A side view of my car.

http://www.flickr.com/photos/tdb11/6408987025/

 

[z28rich]

Richard, See if you can open this. I'm new to Flicker, so I hope it works. A side view of my car.

http://www.flickr.com/photos/tdb11/6408987025/

thanks Tom! thats that I was looking for.your look sweet:thumbsup: some look a little low on the front.thanks again:hurray:

 

[davidpozzi]

69's seem to look best with a 6320, a 6308 is nice on a 67 - 68.

 

[tdb11]

Glad I could fine this Rich and good luck. By the way, I was concerned about the springs settling after awhile but it has been 3 years now and I cannot notice, or measure, and discernable change in height. Thanks to David Pozzis' vast understanding and information available here to all of us, it was his input that set me in the right direction. You can't go wrong with all of the valuable input on this forum!!

 

[z28rich]

Glad I could fine this Rich and good luck. By the way, I was concerned about the springs settling after awhile but it has been 3 years now and I cannot notice, or measure, and discernable change in height. Thanks to David Pozzis' vast understanding and information available here to all of us, it was his input that set me in the right direction. You can't go wrong with all of the valuable input on this forum!!

Tom,did you do anything to the rear springs?

 

[tdb11]

Nope, 12 bolt with four leaf as original.

 

[z28rich]

Nope, 12 bolt with four leaf as original.

thank you very much:thumbsup: