You need to first remove the inside door handle, and then the cup.
The door handle is attached with a screw. Removing the door handle screw is a major pain.

 

Removing the door handle screw is a major pain.

Amen 67 Brother!!

I believe you will also find two little screws in the bottom of the cup that hold it to the Arm Rest bracket.
Sometimes the screws are hard to see if the cup is dirty!:thumbsup:

I have been putting off pulling mine because of that screw now for a month!

 

Welcome Matt. There's lots of good information on this site. Do a search on a topic and usually you will find the answer you need. Steve has you on the right track. Good luck with those door panels.

 

This is why I'm frustrated.
I've done all this and it still will not move.

What's done:
Removed screws along bottom of panel
Removed Door and window handles
Removed (2) screws below arm rest
Undid all clips on left and right side of panel

I'm able to slide the panel a little but it looks like it's being held by one or two "L" brackets that are behind the arm rest next to the door handle. I can feel screw heads on the inside of the panel but there is no access to them (that I can see) on the outside.

 

You also have the two large screws that are located under the molded arm rest area.
Call me if you are around and still don't have it off. I'm in Ventura.

805-625-1937

Tony

 

Now I have to read closer....I just saw you did this!:wacko:

 

Thanks a bunch Tony,
I may call you anyway if/when I have other issues :yes:

 

That was it!!!!! Screws buired under an inch of dirt. Thanks
Can I buy ya a beer????

:hurray: :beers: :hurray: :beers: :hurray:

 

Thanks
Can I buy ya a beer????

Sure!!:thumbsup: Do ever make it to Ventura in your Camaro?
We are going have a cruise up to Carpinteria at the end of June!

 

Actually, I'll be in Ventura This Sat. I'm having lunch at Tailgaters Cafe then going to NPD.
I should be there around 11:30 but w/o the Camaro, it's still in pieces due the the interior restoration.

BTW, there is a small chance I'll flake, let me know if you are planning on being there and I'll call you by 10am Sat if I can't make it.

Matt

 

Matt!

I have to work this weekend

Save my number and PM me yours and I'll keep you up on what's happening with the Camaro get together at the end of this month!:thumbsup:
T.

 

Agreed.
I was lucky enough to find a 5/16 closed end, offset wrench in the box that worked.
Still look forever and was a real PITA!