In process of replacing my Fuel pump, when installing the mounting plate, one of the small bolt heads snapped off...see photo--lower left bolt head missing:
Is this as bad as I think, requiring me to pull the motor so I can get an angle to extract the little bolt, or can I run it without the benefit of this bolt (using the other three--one small, then the two Fuel pump bolts to prevent this from leaking on me)? As some addiitonal informaiton, the gaskets were dressed on both sides
Thoughts...

Is this as bad as I think, requiring me to pull the motor so I can get an angle to extract the little bolt, or can I run it without the benefit of this bolt (using the other three--one small, then the two Fuel pump bolts to prevent this from leaking on me)? As some addiitonal informaiton, the gaskets were dressed on both sides
Thoughts...