Hey Jerry i can take some pics and send to you tonight. did you get the connector kit that doesn't come with the rear brake kit? found that out after i installed the rear's and went to connect the cables!

 

wait.. if you purchase a wilwood disk brake kit with the parking brake, it doesnt come with the connector(s)?

I just bought a front and rear conversion kit from wilwood (4 piston front and rear with 11 inch rotors) for my drum/drum 1968 camaro. Also bought the proportioning valve and mounting kit, as well as a Wilwood Tandum Master Cylinder 1" and Wilwood Dual Diaphram 8" Booster. Now I have to buy the connection for the parking brake?!

Also, if you could post up pictures of your setup it would be greatly appreciated

 

I ordered what they call a universal kit for mine after the fact. The cables do connect to the brake drums. Im just not sure about the best routing of the cables.

 

There are no rear drums?

 

Talk to Lokar. I don't have Wilwood but their kit should be very adaptable. I worked with their engineer years ago to get a kit for SSBC that was actually for an old T-Bird. Works great.

 

I have Wilwood internal parking brake brakes on the rear of my '68. I used the OEM pedal, cable from the pedal through the suframe and the cable to the parking brake lines, and then special ordered custom parking brake lines from Inline Tube. It works very well.

 

I just did the Wilwoods and their parking brake cables. I don't have any pictures of the routing right now. I can snap some later this week.

The passengers side cable is routed over the rear end and attached where the pinch weld is for the back of the floor pan. Once it reaches the drivers side it joins the drivers side cable. They run together up the inside of the subframe connector. Then I mounted the 'block' to the floor pan. I had to modify the threaded end to work with the stock front brake cable. They both needed to be trimmed.

Just make sure all your bends are gradual and not sharp. I used the P clamps that came with the kit.

 

this is the kit i had to order to complete the cables.
http://www.lokar.com/product-pgs/eb...oduct-pgs/ebrake-cables-conn-cables/ebrake-cable-pgs/rearbrake-clevis-kits.html

 

The Willwood parking brake kit came with these. I didn't need anything additional. Just got them less than 2 months ago.

 

I posted pics in this thread: http://www.camaros.net/forums/showthread.php?t=204983

 

Jerry here are a couple pics

 

Thanks James.:thumbsup:

 

sorry, not the best pics, car sits so low it was hard to get my hand up there with the phone to snap the pics! hope this helps